Re: Синхронизация 2-х SP на p570 при FW Upgrade


Главная Форумы POWER Systems AIX/Hardware Синхронизация 2-х SP на p570 при FW Upgrade Re: Синхронизация 2-х SP на p570 при FW Upgrade

#15875

nickalias
Участник
Aliexpress INT

При попытке принудительно запустить процедуру синхронизации через HMC, HMC не дает выполнить это действие-загашена опция “Synchronize Redundant Components”(см.Рис1 файла во вложении).
При попытке показать Display Fix Level Information (см.Рис2 файла во вложении)выдается сообщение с ошибкой HMC E302F82D
Рекомендации по устранению этой ошибки:

Explanation
An error occurred while attempting to read the header of the common marker firmware update file from flash memory to the hard drive.
Problem determination
This error code will be posted under either of the following set of conditions:
· After a service processor failover, the HMC attempted to read the P1 marker LID from the new primary service processor. If the P1 marker LID on the previously-primary service processor had not been synchronized with the P1 marker LID on the now-primary service processor before the failover, this error code will be posted. It indicates that the P1 marker LID file was not found on the now-primary service processor.

This error is not critical; it only effect the HMC’s ability to determine whether or not deferred firmware updates have been applied.
· The files needed to create the P1 marker LID are not available because the HMC is in the process of writing one of them to the service processor. This can happen when a P-side restore runs because a “Do not accept” choice was selected on the advanced features panels. Currently, the HMC will issue an “lslic” command during problem analysis by Inventory Scout scripts. If the P-side common marker LID file is being written to at the time that Inventory Scout script issues the “lslic” command, the E302F82D will be posted.
Action: Install the latest HMC code package, then install the latest system firmware.

HMC у нас v.7.3.5 SP3 т.е. вполне актуальная.
ВОПРОС НЕ В ТЕМУ:
А ЧТО,ЕСЛИ ОТКЛЮЧИТЬ И ВЫТАЩИТЬ primary SP, то можно будет FW Upgrade(ить) secondary SP (который по логике, оставшись один, должен стать primary), а ПОТОМ primary вернуть на свое место, powerOFF-PowerON?

Attachments: