Ответ в теме: Как попасть в SMS меню на 520 (power6) с помощью serial console?

Главная Форумы IBM i (OS/400) Как попасть в SMS меню на 520 (power6) с помощью serial console? Ответ в теме: Как попасть в SMS меню на 520 (power6) с помощью serial console?


Михаил, добрый день!

Пробовали ли следовать следующей инструкции?

To configure a serial console, complete the following steps:

  1. Connect the RJ-45 connector of the serial adapter to the first RJ-45 serial port (labeled P1-T1) on the rear panel.
  2. Using a serial cable that is equipped with a null modem, connect the RS-232 connector of the serial adapter to the RS-232 serial port of the console.
  3. The default baud rate, parity, and word length (bits) should be set to “19200n8”. See Configuring a system port for call options in the Systems Hardware Information Center for instructions for displaying and changing these values.
  4. Power on the system. If the system is already powered on and the console is blank, reboot the system by pressing Ctrl+Alt+Delete. The system will boot and you will be presented with the yaboot<span style=”font-family: Liberation Mono,monospace;”>boot:</span> prompt. If you are using SUSE Linux Enterprise Server, you do not need to complete the additional steps. Proceed to the next step if you are using Red Hat Enterprise Linux.
  5. For serial consoles, the <span style=”font-family: Liberation Mono,monospace;”>console</span> parameter takes the following form:
    <p style=”margin-left: 40px;”><span style=”font-family: Liberation Mono,monospace;”>console=hvsiX</span></p>
    X is the port number (0, 1, 2, etc.). Choosing X=0 selects the first serial port.

    Enter the following command at the <span style=”font-family: Liberation Mono,monospace;”>boot:</span> prompt and press Enter:
    <p style=”margin-left: 60px;”><span style=”font-family: Liberation Mono,monospace;”>linux console=hvsi0</span></p>

  6. View the serial console and verify that kernel messages are being displayed.
  7. Edit /etc/yaboot.conf and replace <span style=”font-family: Courier New, Courier, monospace;”>console=hvc0 <span style=”font-family: Arial, Helvetica, sans-serif;”>with</span></span> <span style=”font-family: Courier New, Courier, monospace;”>console=hvsi0</span> in the <span style=”font-family: Liberation Mono,monospace;”>append</span> line of the default boot target. For example, /etc/yaboot.conf should contain:

<p style=”margin-left: 80px;”>append=”rd_NO_LUKS LANG=en_US.UTF-9 rd_NO_MD console=hvsi0 KEYTABLE=us…</p>
Источник https://www.ibm.com/developerworks/community/wikis/home?lang=en#!/wiki/W51a7ffcf4dfd_4b40_9d82_446ebc23c550/page/Configuring%20the%20Linux%20console%20on%20IBM%20Power%20Systems%20servers

Кроме того, подробно с картинками описано в статье RS232 Dumb Terminals = a painful Blast from the Past

Источник https://www.ibm.com/developerworks/community/blogs/aixpert/entry/rs232_dumb_terminals_a_painful_blast_from_the_past?lang=en

Если понадобиться помощь, пишите.