Re: Мониторинг производительности всего сервера с использованием не

Главная Форумы POWER Systems Виртуализация POWER Мониторинг производительности всего сервера с использованием не Re: Мониторинг производительности всего сервера с использованием не

#13119
pre
Участник

вообще-то пункт 2 это lslparutil
[spoiler][code]hscroot@hmc ]:-> lslparutil
Usage: lslparutil -r hmc | lpar | pool | procpool | mempool | sys | all | config
[-m ]
[-d ]
[-h ]
[–minutes ]
[–startyear ]
[–startmonth ]
[–startday ]
[–starthour ]
[–startminute ]
[–endyear ]
[–endmonth ]
[–endday ]
[–endhour ]
[–endminute ]
[-n ]
[-s ]
[–filter “”]
[-F []]
[–header]
[–help]

Lists utilization data collected for a managed system.

-r – the type of system resources for which events
are to be listed:
hmc – management console
lpar – partition
pool – physical processor pool
procpool – shared processor pool
mempool – shared memory pool
sys – managed system
all – management console, partition,
physical processor pool, shared
processor pool, shared memory pool,
and managed system
config – configuration settings
-m – the managed system’s name
-d – list events for this number of previous days
-h – list events for this number of previous hours
–minutes – list events for this number of previous
minutes
–startyear – list events starting with this year
–startmonth – list events starting with this month
(January = 1, December = 12)
–startday – list events starting with this day
–starthour – list events starting with this hour
(midnight = 0, 11pm = 23)
–startminute – list events starting with this minute
–endyear – list events ending with this year
–endmonth – list events ending with this month
(January = 1, December = 12)
–endday – list events ending with this day
–endhour – list events ending with this hour
(midnight = 0, 11pm = 23)
–endminute – list events ending with this minute
-n – the maximum number of events to be listed
-s – the sample events to be listed:
h – hourly
d – daily
m – monthly
s – snapshot
–filter “” – filters the events to be listed.
The syntax is:
“filter_name1=value,filter_name2=value,…”
or
“”filter_name1=value1,value2,…”,…”
Valid filter names are:
event_types, lpar_ids, lpar_names, pools,
pool_names
-F [] – delimiter separated list of the names of the
attributes to be listed for each event.
If no attribute names are specified, then all
attributes will be listed.
–header – prints a header of attribute names when -F is
also specified
–help – prints this help[/code][/spoiler]со всеми вытекающими ограничениями

ну а пункт 4 без самописных скриптов идёт как опция к IBM i